AVIR

Is there a way to increase the font size on stencils? The elevation drawings put the COMPID right in the center of the stencil, which is of no use to our subcontractors, and the models are way too small to read.

Victorc

If you want to increase the font size to one shape (one time) follows the steps:

1) Select the inserted shape
2) Right click on shape
3) From the right click menu select “Show ShapeSheet” **
4) From the Open window look the “User-defined Cells” section
5) From the row "User.FontSize" change the “Value” Formula as follow:

"Value"
=6 pt*12/User.AntiScale
50% more:
=12 pt*12/User.AntiScale

Note: if you want to increase the font size permanently, do the same steps to the Master Shape.

** If the “Show ShapeSheet” item menu do not shows in the right click menu, do this:

a) From the main menu go to “Tools” > “Options…”
b) Switch to the “Advanced” tab
c) Check the “Run in developer mode” box
d) Click OK
e) Try again the right click on the shape (and continue from the step 3)

__________________
Vic
D-sonic