Line Jump Size - D-Tools Forum

TouchToBegin · 07-15-2008, 10:13 PM

I want to make the line jump size smaller on my shecmatics. Where would I adjust this? I'm thinking the shape sheet for each wire stencil, yes?
Anyone have some insight?

Also, what is the point of automating those line jumps if it won't do it every time. I have some line crossings where there is no visible reason the line jump should not be there, but its not there. I know sometime congestion can flake it out, so I have to move things around and it appears, but I am experiencing problems even when this is not the case.

Thanks.

TouchToBegin · 07-16-2008, 04:03 AM

This turned out to be a Visio setting, not D-Tools.
http://office.microsoft.com/en-us/vi...525961033.aspx

Visio Guy · 07-21-2008, 11:48 AM

Yup,

Just to re-iterate, line jump settings are located under:

File > Page Setup > Layout & Routing Tab

There's a section on the form called "Line jumps", where you can set the vertical and horizontal size of line jumps, as well as what form they take: arc, gap, square jump, and 2 or 3-sided jump.