Hi:
Need a little help with a wire label issue. Using a test Project I built a Bundled Cable using Blake's post (
http://d-tools.us/showthread.php?t=96&highlight=blake+video+bundled+ cable) on how to do so. Worked fine. However when I went to print/review the wire labels, via Brother Wire Label in D-Tools Reports, I noticed that the "Device" and "To" fileds were not populated for the Bundled Cable but the GENERIC Patch Cable I used shows just fine; see image attached.
As far as I know all of the devices are actually attached to the appropriate cable ends; I/O's are correct too.
If it makes adifference, I built the bundled cable from the Main SI screen | Data | Database | Edit. It all seemed to go ok but...
Any help is greatly appreciated!
Jeff
Wire Label Missing Device & To for Bundled Cable
Linear Mode
