Wire: Bulk vs. Fixed Length Interconnects
I have struggled with this for quite some time. We have always had a mix of bulk wire products and Interconnects that are used during the RI phase of a project. Ideally you would want the ability to add a bulk wire item, then set the length and set the HeadEnd. Next you add an HDMI cable to the same drop. The length is fixed but you still need to set a HeadEnd.
A simple checkbox that adjusts the specifications tab as such:
Currently this behavior is not possible. Any additional thoughts?
NOTE: My image should have the "Fixed Length" check box checked...
Last edited by fryeguy; 04-13-2011 at 10:16 PM.
Reason: addition
|
Linear Mode
