Well...
I have installed on a couple of the machines here... And there were som glitches...
There was the issue with I/O Studio, but that one is sorted out, there is a post about it.
I also have an issue with reports, when entering reports it may freeze from 5-10 minutes before it continues. Still waiting for a response on this.
Else..
It has not fixed the problem when working with large drawings, (wirecount above 50ish). It takes a loong time from connecting a cable, before you can connect the next one...
And there is a lot of regional issues not being fixed... I have norwegian regional settings on my machine. causes a lot of error messages.
|
Si 5.2
Linear Mode
