AutoCAD 2012 will not display the D-Tools System interface or menu - D-Tools Forum

skier0522 · 04-27-2011, 05:43 PM

Hello,

I am running Windows 7 Professional 64 bit. I installed D-Tools 5.5 SP3 and am having issues getting it to work properly with AutoCAD. I have used the Longbox software to install AutoCAD 2012 32-bit as shown here: SI5.5 and AutoCAD on a 64-bit Machine - D-Tools Documentation Wiki

I have also run this utility shown here: AutoCAD Vertical Programs - D-Tools Documentation Wiki

Both appeared to work fine, but when I create a CAD file from D-Tools and open it, AutoCAD launches, but neither the D-Tools menu nor the system interface launch. If I type "dtshowmenu", it says it's an unknown command.

How do I address this issue?

Thank you,
Brendan

**Dave Kirn** · 04-27-2011, 10:03 PM

see the answer to your same question in another post

D-tools SI5 SP3 64-bit status

skier0522 · 04-27-2011, 10:09 PM

Hi Dave...that you for the response, but I tired the steps you mentioned in the other post, and it still didn't work.

Thanks,
Brendan

dtechy1 · 05-24-2011, 06:17 AM

Having same issue. skier was your issue resolved?

SenoS · 05-26-2011, 12:43 PM

Have you tried downloading and running the new SIAcadRegistryManager.exe as explained in this post?