Forgive me if this has already come through...I am noticing that if I change the head-end of a rough-in wire in the datamatrix, it does not update the wire on the Visio floor plan. If you change the wire on the plan first, it does update to the datamatrix. This worked fine in SI4.
I am also pleased to hear that the new wire auditor can be turned off in 5.5. The issue of preventing me from making connections I wish to make is bad enough, but it SEVERELY slows down landing wires. In a LanSync setup such as ours, there is a several second pause after every wire is connected. I have also noticed that it often does not work correctly or consistantly, even after I make a choice whether to make a connectionor not when I get the pop-up window. Nor does it update properly after a piece of equipment has been deleted that a wire was once connected to. I am looking forward to killing this pig
Brett Myers
System Engineer
Connected Lifestyle Engineering
by
The Audio Warehouse
Charleston, SC
Wire head-end not updating
Linear Mode
