D-Tools Forum - View Single Post

03-30-2006, 01:42 PM

I am using the text version of d-tools and I also use fixed wire length cable on the proposals. I know this is not the standard way to use d-tools.

I integrated quicklinks recently and now would like all of the cable to transfer over to quickbooks. The only way I can see to do this is to enter cable by the foot. I tried this but 100 feet of wire turned into 100 lines of info in d-tools. When I did a proposal d-tools gagged on the number of lines etc....so this is not the best way to go. Is ther a better way to do this without using the d-tools wire function which I think is too slow for what I do as the engineering etc. is done outside of d-tools.

Anyone come across this, and what did you do to workaround/correct?

03-30-2006, 01:42 PM	#1 (permalink)
KeithC Guest Posts: n/a	Accurate Fixed wire length on proposals I am using the text version of d-tools and I also use fixed wire length cable on the proposals. I know this is not the standard way to use d-tools. I integrated quicklinks recently and now would like all of the cable to transfer over to quickbooks. The only way I can see to do this is to enter cable by the foot. I tried this but 100 feet of wire turned into 100 lines of info in d-tools. When I did a proposal d-tools gagged on the number of lines etc....so this is not the best way to go. Is ther a better way to do this without using the d-tools wire function which I think is too slow for what I do as the engineering etc. is done outside of d-tools. Anyone come across this, and what did you do to workaround/correct?